Guest
Show Posts
1
FAQs / Microcarve
« on: May 30, 2013, 07:33:05 PM »
Anyone out there using Microcarve?
I know that it is a lazy way to generate G Code but it seems to do the trick with the exception that when I load it onto my system using Mach3, the size is way too small.
I am new to the CNC routing game as it is a new hobby.
I am also looking for G Code that will allow me to produce Old English lettering.
Thanks for the support
I know that it is a lazy way to generate G Code but it seems to do the trick with the exception that when I load it onto my system using Mach3, the size is way too small.
I am new to the CNC routing game as it is a new hobby.
I am also looking for G Code that will allow me to produce Old English lettering.
Thanks for the support