Messages

1

G-Code, CAD, and CAM discussions / Re: configuring Alphacam postprocessor for 5 axis mill

« on: June 14, 2013, 03:50:38 AM »

Hi
How I can off auto numbering in post file?
thanks

2

General Mach Discussion / Re: Developing Post Processor

« on: June 02, 2013, 12:52:36 PM »

Again thank you for your useful file.
My Target is to develop a post for AlphaCAM 2013. I think I need to find such file for AlphaCAM but unfortunately I can't find it.
Anyhow, I believe I can learn lots of new things from your file.
Thank you.

3

General Mach Discussion / Re: Developing Post Processor

« on: June 01, 2013, 04:42:51 PM »

Thank you for your response but I would like to learn general rules for developing any kind of post processor codes. I will be appreciated if any one helps me.

4

General Mach Discussion / Developing Post Processor

« on: May 31, 2013, 01:44:06 PM »

Dear friends,
I would like to learn to develop my own Post Processor for Mach3 but unfortunately I can't find any tutorial or training for it. I will be very thankful if you share your knowledge and experiences with me.
Thanks a lot
 

5

G-Code, CAD, and CAM discussions / Re: AlphaCAM, Mach3 milling post processors

« on: May 25, 2013, 01:40:47 AM »

Hello dear friends,
I am just new here. your forum is very good and useful.
I have a problem with Mach 3 & AlphaCAM 2013. I hope you could help me. I have downloaded your Mach 3 post processor but unfortunately my Milling Machine does not support it. I have a 2.5 axis CNC milling and I use ArtCAM for my modeling and G-Coding. In ArtCAM I  use Mach 2 mm.cnc post processor. But I can find anything like this for AlphaCAM. Can you help me?