1
General Mach Discussion / Re: Live feed gcode into mach3 - is there a plugin / vbscript / c++ code?
« on: May 21, 2013, 08:04:04 AM »
thanks, but when i execute gcode lines over vbscript it is basically the same?
Especially its important that i give it batches of lines, so the acceleration can be calculated accordingly - so that it doesn't stop after every line..
anyway - after a little vb research i found something called "named pipe" which is, as far as i understand, the same as a filestream, but without the access violation problems..
another way would be some kind of c# dll which can call from vb..
Especially its important that i give it batches of lines, so the acceleration can be calculated accordingly - so that it doesn't stop after every line..
anyway - after a little vb research i found something called "named pipe" which is, as far as i understand, the same as a filestream, but without the access violation problems..
another way would be some kind of c# dll which can call from vb..