1
General Mach Discussion / Re: Interface between Labview and Mach3
« on: May 16, 2013, 08:58:54 AM »
Oops.. sorry about the multiple posts. I thought of using labview because we already have a feedback control system based on that and I thought I could use that as a starting point for my system. I am new to all this and so I am sorry if this sounds silly. What does Cyprus enable exactly do? Will I be able to continuously monitor the current values and when it reaches the threshold move the stage down in Mach3 itself with using Labview only to get the current data from the set up?