Hello Guest it is November 20, 2019, 09:04:04 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dougharris

Pages: 1
1
Need Suggestions on what hardware we need to convert an Older Thermwood c50 to Mach3.  The CNC has Big MHO ( Baldor Servos) and West Amp Drivers # 33026-5.  What Interface Boards will work with this config ??  Would we be better off changing out the Old Servos and Drives to new?  We had a 5' X 10' Omnitech with Fanuc PC Front-end, but had to sell last Fall.  So we are taking this Heavy Duty Router and trying to interface with Mach3. Any help would great !!

Pages: 1