1
FAQs / Re: guide to wiring a new machine
« on: May 06, 2013, 03:52:28 PM »
Then my outputs will be via the Modbus RJ45's to x y and z with direction and steps. Spindle too.
I have y3 as the oiler, which I think is the way they lube up the slide ways for axis travel.
Also lube for the tool, run on output y4.
My big question is:
when the mill needs to home, will it need to escalate from estop enable to hardware enable and then to drive/servo enable? or will it be able to jog the axis's whilst in hardware enable without the variable speed drives receiving the drive enable signal?
I have y3 as the oiler, which I think is the way they lube up the slide ways for axis travel.
Also lube for the tool, run on output y4.
My big question is:
when the mill needs to home, will it need to escalate from estop enable to hardware enable and then to drive/servo enable? or will it be able to jog the axis's whilst in hardware enable without the variable speed drives receiving the drive enable signal?