Hello Guest it is January 20, 2021, 08:51:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - xhuxhi

Pages: 1
1
General Mach Discussion / Re: Control Mach3
« on: May 05, 2013, 02:36:51 PM »

Thanks...i looked at this post

 http://www.machsupport.com/forum/index.php?topic=23759.0 ....

 it helped me a lot to understand how the modbust and Brain Controller works....

Thanks

2
General Mach Discussion / Re: Control Mach3
« on: May 04, 2013, 01:52:12 PM »
I was talking about  mach3 when i said beginner, and not in microncontroller or serial port softwares ... so you wanna help or what?


3
General Mach Discussion / Re: Control Mach3
« on: May 04, 2013, 12:07:26 PM »
Hi.. thanks for the reply...i am very begginign and i don't know nothing... can you guide me just to create a very simple program in modbus...any way is ok for me... just i want to achieve the result..

4
General Mach Discussion / Control Mach3
« on: May 04, 2013, 11:14:21 AM »
Hi, i am new in mach3... but i have experience in software for serial communication and microcontrollers programming, i was wondering if there is some possibility to control mach3 from outside software through serial port?

Example: Serial Com 2 <--> Com 3 (Com 2 and 3 are virtual serials linked )

I want to start milling after i type "Go" from one software (Not Mach3)... after typing  "Go"  from my X-program, i write something to serial port Com 2 (maybe some byte data), I want mach3 to recognise this data byte from the serial and start some G-code.... i hope i was clear :P ..

So, is it possible or not... maybe using the vb scripting or modbus i don't know... please help me here...

Thanks in advance

Pages: 1