Hello Guest it is March 28, 2024, 03:58:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - djk

Pages: 1 2 »
1
General Mach Discussion / Re: Mach3 wizard problem
« on: April 18, 2014, 06:40:06 AM »
Thanks Hood everything is working fine now.

David

2
General Mach Discussion / Mach3 wizard problem
« on: April 17, 2014, 04:05:36 PM »
Hi

I had a old Demo mach3, every thing worked well. I updated and brought a license, now I have a problem with the wizards- cut circle - kiran.
First thing, when I have X center and Y center 0 the center is off to the side and the finish pass is off center. Second thing is circle Dia and tool Dia are wrong. I have to change these to circle radius and tool radius to get the right size circle.
If some one can help.

Thanks David


3
General Mach Discussion / Re: External Estop Requested
« on: April 26, 2013, 01:44:34 PM »
Yep I have very nice rubbish bin in my garage

4
General Mach Discussion / Re: External Estop Requested
« on: April 26, 2013, 09:33:48 AM »
Earth mains to earth of the driver (PE)
The driver is on a wooden board pluged in to the mains no motors or BOB

5
General Mach Discussion / Re: External Estop Requested
« on: April 26, 2013, 03:48:14 AM »
Ripped every thing out of my control box and tested the drives.
I have 100VAC on the earth and 230V on R+ of the motor connection. ( the 3 drives )

6
General Mach Discussion / Re: External Estop Requested
« on: April 24, 2013, 10:54:28 AM »
Tested one of the motors its ok. the stepper drives are at fault?

Thanks for your help

David

7
General Mach Discussion / Re: External Estop Requested
« on: April 23, 2013, 03:31:30 PM »
These motors were bought two years ago new and wired up for testing a week ago ???
Sanyo Denki $$$  :'(

8
General Mach Discussion / Re: External Estop Requested
« on: April 23, 2013, 12:23:47 PM »
Im up two 50 000, so decided two check all my wiring.Took the earth off the machine, got a spark, so tested the 3 motors ,30vac 60vac and 70vac between the motors and earth.I dont think this is normal ?


9
General Mach Discussion / Re: External Estop Requested
« on: April 23, 2013, 06:12:04 AM »
Hi Hood

I started with 2000 but have reached 20 000 for the moment.Will this be a problem or would it be better to change my drives

Thanks

10
General Mach Discussion / Re: External Estop Requested
« on: April 22, 2013, 05:42:50 PM »
Thanks I will try it tomorrow morning

Pages: 1 2 »