Messages

1

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: July 22, 2015, 11:55:16 AM »

Thanks.

 I was thinking that was the way to do it i just wanted to make sure before making a mistake.

2

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: July 22, 2015, 11:39:31 AM »

Hi

I love the screen just need a little help. Where is the axis calibration located since i am having a hard time finding it? Do i need to do it in the original screen then swap over and if so will it mess up the motor tuning swapping from screen to screen?

3

One on one phone support. / Re: Need Help

« on: April 15, 2013, 07:00:41 PM »

Mach3 thus the reason i posted it in this section.

4

One on one phone support. / Need Help

« on: April 15, 2013, 05:53:57 PM »

I am having problems and need to speak to someone ASAP not looking to explain the problem just need a person to talk too... send me a pm with contact info.

5

Mach3 and G-Rex / Re: Newbie help Please!!!!!!

« on: April 15, 2013, 05:25:39 PM »

I would also like to know this info.