Hello Guest it is October 20, 2021, 07:35:18 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Hockeyguy01

Pages: 1 2 3 4 »
1
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: October 14, 2013, 08:21:58 PM »
Is the speed the jog and step increments?

2
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: October 14, 2013, 03:09:58 PM »
Hi Ger

I have been try to set up my machine with the x y probing. I think I have a setting wrong somewhere. When I hit the y- button ot will start to move in that correct direction but it is at a rapid rate. The same happens on the x+ direction. I have my job rate 00% and my step increment rate at .01. Is there anything else I should check.
They are on the left side below the buttons.

3
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: October 09, 2013, 09:25:42 PM »
and this will give me the zero location that I am looking for

4
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: October 09, 2013, 09:02:34 PM »
I am looking for some advice on probing. I have attached a diagram of what I am trying to do.

5
Newfangled Mill Wizard / Re: Tool Path Still Not Displaying
« on: August 07, 2013, 10:01:10 AM »
Thanks Ron

I just emailed them the request.

Mark

6
Newfangled Mill Wizard / Re: Tool Path Still Not Displaying
« on: August 06, 2013, 08:06:27 PM »
hi guys I just down loaded the newest update v1.0.11 and installed on my computer that I had the bought version on it. when I goto help it says I have the demo version. I had asked Ron how to install a new version an I thought I just had to install over it. what do I do to get this new version under my correct account so I can see the tool paths?

I just reloaded old file set up I have the licensed version working again. how do I install the update?

7
Newfangled Mill Wizard / Re: Tool Path Still Not Displaying
« on: July 31, 2013, 12:00:17 PM »
What version has the fix for my issue that you helped me with above?

Thanks

Mark

8
Newfangled Mill Wizard / Re: Tool Path Still Not Displaying
« on: July 30, 2013, 08:55:35 PM »
Hi Ron

I see there is a new version of the newfangled program. I have purchased a version from you already how do I install the update to my system?

9
Newfangled Mill Wizard / Re: Tool Path Still Not Displaying
« on: July 26, 2013, 01:19:44 PM »
ok great thanks for the help

10
Newfangled Mill Wizard / Re: Tool Path Still Not Displaying
« on: July 26, 2013, 10:25:52 AM »
Thanks for looking into this for me

Pages: 1 2 3 4 »