Messages

1

Galil / Re: Camsoft -> Mach3 ->Galil 18420 ->Adlink PCI-7296 I/O help please

« on: December 31, 2014, 12:03:55 AM »

G'day Steve,
Been having a catch-up on the forums after a fair bit of time.
Sounds like you fellas are getting somewhere with Mach4, which is great.
I figured this might be the quickest way to find out if Mach4 will improve my chances of using Adlink PCI-7296 for extended I/O with the Galil 1842.
Had a search for both cards from what I read all should be good with Galil1842.
Couldn't find anything regarding Adlink I/O

Thanks for your help - love ya work
Happy New Year

2

Galil / Re: Camsoft -> Mach3 ->Galil 18420 ->Adlink PCI-7296 I/O help please

« on: June 28, 2013, 01:27:30 AM »

Thanks Steve
I saw you post the same info in another thread.
So I would definietly need a plugin?
I don't have the capacity to write a plugin, I've got a problem, any suggestions?
I have 4 Opto22 G4PB24 relay cards only using two of them 1 with 21 inputs the other 23 outputs.
I haven't used any of the 8 inputs or 8 outputs on the Galil 18420.
Any suggestions on a way through?
Much appreciate your post.   

3

Galil / Camsoft -> Mach3 ->Galil 18420 ->Adlink PCI-7296 I/O help please

« on: June 22, 2013, 10:01:58 PM »

G’day Folks
I’m part way through retrofitting a 1989 SCM router with Camsoft, now I’m thinking I should attempt using Mach3
I’ve got Mach3 recognising the Galil 18420 but that’s all so far.
What I haven’t discovered from the forums is how to get Adlink PCI-7296 I/O card into the picture.
Some posts indicate this is not possible.
Is anyone able to point me in the right direction for further information?
Any help much appreciated.

4

General Mach Discussion / Re: Mach3 vs NC-studio

« on: May 10, 2013, 07:03:38 PM »

Jallit, I'm trying to do exactly what you have done. Changing an NCstudio machine to Mach3.
I'm trying to figure out how you configured mach3 to control the spindle with the 3 outputs to VFD.
Could somebody point me in the right direction please?