Hello Guest it is November 27, 2021, 03:53:00 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - RDeVries

Pages: 1

Has anyone converted a Probotix Fireball Comet to MACH3 from EMC2?

I was told that MACH3 couldn't run this little table due to the dual Y axis steppers.  I had a Plasmaroute table with a dual Y axis stepper and MACH3 didn't have any issue with it.  What I am hoping for is that someone has a configuration file I could try.


Thank you,

Pages: 1