Hello Guest it is November 19, 2019, 02:21:15 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - GKDSportsCars

Pages: 1
1
Hi Guys,

I've just added a micro switch to a floating head and have that working on the Mach3 milling interface fine (I couldn't see how to manually test this within the MACH 3 Plasma screen). I have also added a Proma THC which seems to work with the MACH3 Plasma screen... but not very well. I am hoping that is down to not being able to set Z to 0 accurately without the floating head and hence why I fitted a floating head in the first place!
My question is what Sheetcam post processor should I use to enable Z to be set to 0 with the floating head between each pierce and then also enable the Proma THC? I'm very new to G code so if customisation of the post processor is required then any help would be greatly appreciated.

Thanks in advance,

Peter

Pages: 1