Hello Guest it is September 27, 2020, 04:41:15 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - maxpower

Pages: 1
1
General Mach Discussion / 305 motor stalling
« on: March 31, 2013, 06:24:45 AM »
HI
I'm just starting out with CNC, I currently have Hobbycnc board, I'm having trouble getting my X axis to run smoothly.
my y axis 205 stepper motor 3V 3A runs perfectly
my X axis is a 305 stepper motor 4.2V 3A
it runs in jog mode fine but when running a test g code it stalls and vibrates
I have tried changing the velocity and the acceleration, but I can either get it to run smoothly at low speeds or at high speeds but never both

2
HI
I couldn't find where to post this so if anyone could redirect me
I'm just starting out with CNC, I currently have Hobbycnc board, I'm having trouble getting my X axis to run smoothly.
my y axis 205 stepper motor 3V 3A runs perfectly
my X axis is a 305 stepper motor 4.2V 3A
it runs in jog mode fine but when running a test g code it stalls and vibrates
I have tried changing the velocity and the acceleration, but I can either get it to run smoothly at low speeds or at high speeds but never both

Pages: 1