Hello Guest it is December 06, 2019, 01:06:45 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - MaDMeTaLs

Pages: 1
1
Hello All,
My name is Byran McWaters and I have had no previous experience with CNC but I have gone headlong into a 4 x 8 Precision Plasma table, CandCNC ESP II, Mach 3, and a PM 65 mech torch.  I've got my table built, wired, and power to the motors. I'm  now trying to sift through the endless set up instructions and get the motors to "simply"jog ; )  I'm stuck with the External EStop requested error.

Pages: 1