Messages

1

Third party software and hardware support forums. / Re: optimum kontroller IV

« on: May 13, 2020, 03:33:58 AM »

Hello.
The 1st pin on the DB25 connector needs a signal from the charge pump,
or + 5V no matter from any source.
That should help
Indulis

2

General Mach Discussion / Re: Recommendations on BEST Breakout Board by General Mach3 Users !

« on: December 05, 2015, 11:31:18 AM »

For one and a half years I worked with home-made milling machines with 4 servomotor drive.
it is controlled by USB MotionCard AKZ250
I attach Move block diagram
For me it works very well without mistakes
Of course all connections are shielded me.
Indulis

3

Third party software and hardware support forums. / Re: optimum kontroller IV

« on: December 05, 2015, 10:34:36 AM »

Hi Tobbe

For the second year, I was working at home with a home-made milling machines mach 3, so I have already got used to the program.
I work at school, and next week we will supply school workshop lathe and milling machines with optimum Kontroller IV.
I also have an idea of continue to use Mach3.
AS SOON AS I receive Optimum Kontroller IV write how I will succeed.
I am going to use withDDSM4V5.0 200KHz 4-Axis CNC USBMACH3 Card Interface Board

Indulis

4

Third party software and hardware support forums. / Re: HELP WITH OPTIMUM CNC CONTROLLER VI AND MACH3

« on: November 29, 2015, 04:39:42 PM »

Hi

Please then share information.
 I also require adapting OPTIMUM CNC CONTROLLER to Mach3 Milling.
Indulis from Latvia