Hello Guest it is December 03, 2021, 07:40:19 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DennisPC

Pages: 1
1
I did a Google for it and it can be related to a few things but most likely is you may have a trojan.
Hood

Ya I came to a similar conclusion from my research. However, it is strange because I downloaded the file from machsupport.com.

2
I get the same error when installing in the C drive. Any other ideas?

3
General Mach Discussion / Mach 3 Demo Install: "Illegal Instruction"
« on: March 19, 2013, 04:48:29 PM »
Hi Everyone,

I am very new to the world of CNC. I am trying to setup a MaxNC router table outfitted with a Probotix 4 axis kit. I am running Windows XP Professional 32-Bit. When I try to run the Mach3 installer (downloaded from machsupport.com) I get the following error:



Now, does anyone have any idea what the problem is? Any suggestions on possible solutions?

Thanks

Pages: 1