1
General Mach Discussion / Re: Motors jerking and loosing zero on low speeds
« on: February 28, 2013, 04:00:06 AM »
Fixed in the early hours of today :-)
Id renamed the file .dat when it already had the extension I just couldn't see it because of XPs silly settings!
I think ive remidied the jerky motors but am not 100% sure, todays testing will tell.
Ive rewired with sheilded cable and earthed the shielding but also now switched to 1/16 stepping which seems much happier at slow speeds.
Its been suggested to install 20 to 50Uh chokes on the motor leads too which is next if I see issues still.
Thankyou
Id renamed the file .dat when it already had the extension I just couldn't see it because of XPs silly settings!
I think ive remidied the jerky motors but am not 100% sure, todays testing will tell.
Ive rewired with sheilded cable and earthed the shielding but also now switched to 1/16 stepping which seems much happier at slow speeds.
Its been suggested to install 20 to 50Uh chokes on the motor leads too which is next if I see issues still.
Thankyou