Hello Guest it is April 09, 2020, 04:02:51 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cjtoombs

Pages: 1
1
I found the problem.  I had not installed my Mach3 licence.  My old computer crapped out, and when I set the new one up I forgot to add the licence file.  Once I did that, it worked like a charm, with the original Wizlic.dat file I had in there.  Thanks for the help.

2
Ok, just verified that the WizLic.dat file is in the same directory as the Mach3.exe.  Also, deleted the one in there and recopied it there.  Restarted Mach and tried it again.  Still geting "Unlicenced Wizard File" message. 

3
It all works fine, just won't post the G code.

4
I put the WizLic.dat file in the PCNC3 folder, and the wizards are not working.  Is this the correct place to put the file, and if so, is there anything else that I need to do?

Pages: 1