Messages

1

General Mach Discussion / Re: Problem Mach3

« on: July 24, 2018, 12:41:00 PM »

Back up and running, I want to thank you again..

ED

2

General Mach Discussion / Re: Problem Mach3

« on: July 24, 2018, 11:51:43 AM »

Thanks for the quick response I'll see what I can do and let you know..

Thanks again Ed

3

General Mach Discussion / Problem Mach3

« on: July 24, 2018, 11:15:10 AM »

Hello All,
I"m having a problem with Mach3 worked fine last time I used it bit now when I open the mach3 loader and select my 540BVFD windows shuts down and restarts. I running windows 7 Pro not sure whats going on any help would be greatly appreciated.

thanks Ed

4

General Mach Discussion / Re: Need Help

« on: June 10, 2014, 07:27:04 AM »

Thanks, I'll try that and let you know if it works.

5

General Mach Discussion / Need Help

« on: June 08, 2014, 11:26:53 AM »

I have a Vortech CNC Router and am running Mach 3 my problem is when I'm cutting curves or large radius I get a lot of chatter, it's almost as if the steppers are fighting each other. Not sure  if that makes any senses. If anyone as had a problem like this or has any ideas I'm open for suggestions
 

6

General Mach Discussion / Re: Lost software

« on: February 14, 2013, 06:31:16 PM »

Thanks I'll try that

7

General Mach Discussion / Lost software

« on: February 14, 2013, 06:22:31 PM »

Hello my name is Ed and I’m new to the group and wanted to know if anyone can help me out?  I purchased a Vortech CNC system a couple years ago and it came with  Mach III and I had it registered.  My computer crashed and I lost everything on my hard drive. Is their any way to get another copy of the software.