Hello Guest it is March 28, 2024, 05:28:28 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mikes racing

Pages: 1
1
General Mach Discussion / Re: X and A
« on: February 26, 2016, 02:56:21 AM »
At the moment I run the machine as a CNC but would like to try the 3D printer set up I need to run the extra driver for the exturder.

Mike

2
General Mach Discussion / X and A
« on: February 25, 2016, 04:06:55 AM »
I have a four drive control board and would like to use one to drive some thing else can I use a Y lead to connect X and A so this frees up a driver or can I add a fifth driver some how?

Mike

3
General Mach Discussion / Mach3 3D Printer Extruder
« on: February 04, 2016, 03:31:11 PM »
Hi all, I have a cnc running mach 3, I am using all four drivers on the controller,  how can I drive a stepper for a extruder for a 3d printer on this machine?  I have it all ready but for this Mike

4
Mach Screens / 2010 screen set
« on: March 26, 2015, 03:12:07 AM »
Hi, can any one help I have been using the 2010 screen set since it came out, I have changed my computer and paid again but I can not find where to down load it.
Please help
Mike

5
General Mach Discussion / Re: Gecko 540
« on: June 19, 2014, 02:30:35 PM »
Thanks all. All done and I am well pleased with all the help and the new Gecko.

Mike

6
General Mach Discussion / Re: Gecko 540
« on: June 18, 2014, 02:59:26 AM »
Hi All,
Thankyou for your replys. It was thw 25 pin cable I bought a new male to male and it did not match up. I went to maplins and bought a conveter female to male and it works.
I now have a problem on the Z it will not run smooth and go's in any direction .
Mike

7
General Mach Discussion / Gecko 540
« on: June 17, 2014, 09:27:47 AM »
Hi  all, long time no see.
All was working well when bang my controler gave up, I have bought a gecko 540 and have wire it up using all new wire and conectors. can anyone help I have power to motors and I can get DRO's to move in mach but I can't get the motors to run. It seems like no signal. This is my work so I need it up and running asp.
Many thanks

Mike

Pages: 1