Hello Guest it is March 29, 2024, 04:29:46 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mrobertson

Pages: 1
1
General Mach Discussion / Re: Homing Issue on X-axis Only
« on: February 06, 2013, 11:54:25 AM »
Okay, I've been going through the setting some more, and it appears that the EStop is set to the same pin as the X-Axis home switch.

I thought I disabled it before, but I guess you can't.

2
General Mach Discussion / Re: Homing Issue on X-axis Only
« on: February 06, 2013, 11:41:37 AM »
Version R3.043.066

3
General Mach Discussion / Homing Issue on X-axis Only
« on: February 06, 2013, 11:29:45 AM »
I have a CNC router that I recently replaced the breakout board to a cnc4pc
C11G. I was setting up Mach3, and everything seems to work just fine except for
when I home the axes. The Y and Z home perfectly fine. They trigger the
proximity switches and back off, but the X axis triggers it's switch and doesn't
back off. It just stops at the switch and keeps it triggered.

Then I have to Reset, then toggle the active switches, move the X-axis, it
triggers the proximity switch again, reset, toggle active switches, and then I
can move the X-axis freely.

I also have all the axes set with Auto Zero enabled, and that doesn't seem to
work either.

Any ideas?

Thanks,
Matt

Pages: 1