1
General Mach Discussion / Re: Lost steps - again?
« on: February 05, 2013, 01:05:03 PM »
Thank you!
I will try and see, but I think you are right...the problems started when I was tring to make a 32MB toolpath.
Never experience this issue before, however I will try to break the code in 3 or 4 smaller parts to avoid this issue
I will try and see, but I think you are right...the problems started when I was tring to make a 32MB toolpath.
Never experience this issue before, however I will try to break the code in 3 or 4 smaller parts to avoid this issue