1
General Mach Discussion / Re: mach 3 turn doubt
« on: February 12, 2013, 04:42:51 AM »
hi rich
thanks for the info.
i am able to bring the tool to start position using g54 fixture offset.
why GO TO Z option is not available in turn as in mach3 mill as i can avoid typing g54 command in MDI
thanks for the info.
i am able to bring the tool to start position using g54 fixture offset.
why GO TO Z option is not available in turn as in mach3 mill as i can avoid typing g54 command in MDI