Messages

1

General Mach Discussion / Re: mach3 (?) - machine doesn’t finish the cut as it suppos to

« on: January 22, 2013, 11:52:59 AM »

OK
So I need to increase the acceleration valuse?

Thedemri

2

General Mach Discussion / Re: mach3 (?) - machine doesn’t finish the cut as it suppos to

« on: January 21, 2013, 02:14:49 AM »

Thanks Thedemri

3

General Mach Discussion / Re: mach3 (?) - machine doesn’t finish the cut as it suppos to

« on: January 20, 2013, 05:42:51 PM »

Hal
Thanks , it worked perfect!



I just spend a day and a half on this problem! 

Thanks again Thedemri

4

General Mach Discussion / Re: mach3 (?) - machine doesn’t finish the cut as it suppos to

« on: January 20, 2013, 05:03:31 PM »

Hi
Thanks
its engraving now and it look like it helped a lot!

I will put a picture in 30 minuets.

when do we need to use the G64 insted of the G61?

is there a place that i can put the G61 as a default?

Thedemri

5

General Mach Discussion / Re: mach3 (?) - machine doesn’t finish the cut as it suppos to

« on: January 20, 2013, 04:22:39 PM »

hi
thanks , I am a littel bit new be , how do i turn on the G61 ?

Thedemri

6

General Mach Discussion / mach3 (?) - machine doesn’t finish the cut as it suppos to

« on: January 20, 2013, 04:07:26 PM »

Hi
I am using sige x2 converted mill with mach 3
I have tried to engrave letters and logo on dual colored plastic.
And I have noticed that the machine doesn’t finish the cut as it suppos to do.

As you can see form the screen picture , the letters have 90 degrees angels on the corners but the cnc is cutting it with a "short cut " to the next points.






The same is happening on the Z axis and it doesn’t finish the letters (or the logo).
I have tried to generate the code with the Lazycam and solidcam and the results are the same.
Any suggestion?

Thanks thedemri