Messages

1

Mach3 and G-Rex / Re: feed rate overrun

« on: January 13, 2013, 05:02:07 AM »

thanks  gerry very much

2

Mach3 and G-Rex / Re: feed rate overrun

« on: January 13, 2013, 05:00:26 AM »

 hello every one
   i find  solution to my problem  infact  i did not put feed in my g code program, i thought it is 6  by  default,however i realise it picks  whatever i command it in g code program

3

Mach3 and G-Rex / feed rate overrun

« on: January 12, 2013, 09:40:40 AM »

 hello every one
 i m new to mach 3, i have assembled all parts n used mach 3 trial version, axis do not move as fast as they should or as fast i want  them to move, feed rate it show is 6, then for the given program it simulated expected time say 60 minutes,
then i selected max feed rate over run it show 18...or 300% but still it is slower, simulation expected time show about 40 minutes,it is still not satisfactory, i want to know if paid  version of mach 3 allows  feed rate overrun more than 300%,[[ my program involves interpolation.. and i have tried  by changing velocity and acc time in motor config for each axis ]]
  plz  reply soon  thanks