Hello Guest it is March 28, 2024, 10:20:22 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rneelypens

Pages: 1 2 »
1
hey got an email from bd tools with the settings for my a axis, you were right on! but heres is what he sent! steps 11.11111111 velocity 18000 accel 3000 hey its back working now with my codes! but i had to reverse my x axis? oh well thanx for your help! ron neely!

2
hey did you send the email with the pics 4th axis settings? ron just curious different email address?

3
hey im not sure how to check if the motors move 1 inch? tried to set my a axis faster but my x axis is still barely moving when i try to run my spiral or the 2nd code i sent you. but when i run the 1st 6 sided code the x axis works fine but when it comes back t 0, the a axis just spins! i obviously dont have my settings right but not sure how to fix them? ron did you get my gcodes, & my xml files? can you tell anything from them what i need to set my motors to? thanx ron

4
ok tried that but still moving very slowly, barely turning in the a axis & only cutting it round very very slowly? maybe i need to change some other settings? im going to send a gcode i use for this & maybe then u can help figure out my problems! but im going to send to your email, since it took me so long to get it created, dont really want to post it on here? thanx r neely!

5
18 on the motor pulley & then its 36 teeth on the indexer driven by a belt! the indexer s what i need to move in degrees, & where wopuld i change these settings? thanx r neely

6
ok try this just reread what u said before!

7
ok the number of teeth on the motor is 18 & the indexer has 36 teeth. i have been trying to attach my xml file but cant get it work! 1 more try? thanx for your help, r neely!

8
hey no problems, thanx again r neely!

9
ok emailed the guy at bd tools to get number of teeth since i would have to take it apart to count them, ill let yo know when i get the teeth count! found something on the net which says i should set my a axis to .001 to read in degrees? not sure what to do? but i really appreciate your help! thanx r neely!

10
hey thanx for the reply! ok which xml are you asking for? i do not have a link to the 4th axis, since i bout it from ebay & the seller does not have a website or any more listed now! but it is driven by my 4th axis stepper motor which i ordered with my mill from deepgroove, & it has belt drive to the rotary indexer, which was set up to read g codes by degrees not inches! i know there were some settings for my 4th axis that my x friend had me change? but not sure which ones! i tried to load an xml from deepgroove to set up my mill after i reinstalled mach 3 with a license, but didnt have any 4th axis settings for my belt driven indexer to help so nothing changed? heres a link to my mill i bought! http://deepgroove1.com/cncmill.htm  heres some examples of my spiral pens. http://www.pbase.com/rneelypens/spiral_design_pens&page=all
 thanx for you reply & i hope you can help me? thanx ron neely!

Pages: 1 2 »