Messages

1

General Mach Discussion / Re: regulating pwm spindle

« on: December 30, 2012, 11:23:45 AM »

Thanks

2

General Mach Discussion / regulating pwm spindle

« on: December 28, 2012, 04:06:09 PM »

Hello everyone I'm Italian and I'm starting to use Mach3.
  Installation ok, calibration axes too.
The only setting that I can not do is adjust in pwm spindle.
I think I have everything set right but when I press iltasto "spindle cw" the spindle begins to rotate at low speed but when you press + or minus keys to adjust the RPM spindle speed increases up to the maximum and there is no possibility of adjustment.
Can someone tell me where I went wrong?
thanks