Hello Guest it is April 19, 2024, 11:43:49 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 1601chief

Pages: 1
1
General Mach Discussion / Re: tool z zero
« on: November 12, 2013, 01:38:37 PM »
Using standard screen set but script from internet.

2
General Mach Discussion / tool z zero
« on: November 12, 2013, 11:24:37 AM »
What am I doing wrong? I am pushing the tool zero button in mach3 and it stops running at limit switch.  I push reset but does not retract to 2" like I want. If I run the script from the edit script, it all runs fine. ???

Pages: 1