1
General Mach Discussion / Re: Shoptask 1720 gold.
« on: December 17, 2012, 07:37:17 AM »
Hey Turboman,
I'm new to this site.I found this post by searching Shoptask .I know this is an old post and I don't know if you are still around but I thought I would give it a try. I have a shopmaster 2000 and I want to increase It's lift and stiffness. I don't even have the quadralift and I don't want one. I always thought the design was bad, but maybe better than the single 80mm post I have. The structure of your twin post design I like a lot. I want to go with even larger posts, 5"and heaver base, but I had a couple of questions, if you don't mind sharing. How did you make stops/locks for your unit? I guess I just want more specs. and pics so I don't have to start from scratch. If you don't want to share, I understand. Thanks either way
Bruce
I'm new to this site.I found this post by searching Shoptask .I know this is an old post and I don't know if you are still around but I thought I would give it a try. I have a shopmaster 2000 and I want to increase It's lift and stiffness. I don't even have the quadralift and I don't want one. I always thought the design was bad, but maybe better than the single 80mm post I have. The structure of your twin post design I like a lot. I want to go with even larger posts, 5"and heaver base, but I had a couple of questions, if you don't mind sharing. How did you make stops/locks for your unit? I guess I just want more specs. and pics so I don't have to start from scratch. If you don't want to share, I understand. Thanks either way
Bruce