Hello Guest it is March 04, 2021, 08:23:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jjellingson

Pages: 1
1
General Mach Discussion / Re: Xbox controller problems
« on: December 15, 2012, 12:14:18 PM »
Finally, up and running. Works excellelnt, this is a great add onwould recommend it as an additon for  anyone. I just hope they can figure out all the little glitchs easier than I did.

2
General Mach Discussion / Re: Xbox controller problems
« on: December 15, 2012, 07:28:08 AM »
my problems are very similar to the other post you listed. I need to figure out if mine is a knock off controller or the real deal. I remember reading a post about checking the vendor and product id in windows but not sure if I will know what the numbers mean. Thanks for the help.

3
General Mach Discussion / Xbox controller problems
« on: December 13, 2012, 09:57:07 PM »
newbie in need of help. trying to install a wired xbox 360 controller and can't get any movement in Mach3. I can get the pc to recognize the controller. I have what I think all the correct drivers installed. Now I notice I get an error message when starting Mach3, something about a corrupt file, no license, mach4. I have the xbox plugin checked, I need to check to make sure all the others not need are not checked, I think the joystick is still active. I did notice the box for controller says none. Any help would be greatly appreciated.

Pages: 1