Hello Guest it is November 30, 2021, 07:59:37 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - OziBob

Pages: 1
1
General Mach Discussion / Strange error message
« on: December 12, 2012, 03:39:01 PM »
Hi all,

I am new to this forum but have used Mach3 for about three years.

All of a sudden I am getting a blank error message box as the system starts and then a blank screen well it just has the menu at the top and some empty boxes.
I have attached the error message to this post.

I have a flat battery on the clock of the PC I am using and last time I started the machine I did not set the clock in CMOS as I normally do, I note that the *.dat files all have 1980 dates! I am wondering if this is the problem? I so does anyone know how I can safely change the dates on these files. I should add that doing a view/load screen... loads the screen with DROs which are all set to 0

Also before you ask I am not smart enough to have backups of the *.dat files!!!

Pages: 1