Hello Guest it is November 15, 2019, 08:07:32 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - homecockpitbuilder

Pages: 1 2 »
1
LazyCam (Beta) / Re: text engraving
« on: June 15, 2007, 04:35:55 PM »
Hello Graham,

Can you tel me how to pocket the font out?

Regards Bas

2
LazyCam (Beta) / Re: text engraving
« on: June 13, 2007, 03:41:19 PM »
Ok now i have a text. Now my next question is:
 How can i let only the inner cut? The text must be engraved with only one line Now it's going around the letter.

regards:

Bas

3
LazyCam (Beta) / Re: text engraving
« on: June 03, 2007, 07:36:06 AM »
Strange, Can someone explain howto inport a autocad 2007 dxf file with a futura bold text  in lazycam? When i do this it says that there are no line's in it?

Bas

4
LazyCam (Beta) / text engraving
« on: June 02, 2007, 10:29:00 AM »
Hello,

How far is the devolepment for text engrave with the new lazycam?

I now its working in the old one but get a lot of problems with it.

Bas

5
Competitions / Re: ******Guess and win a G100 Grex******
« on: May 22, 2007, 11:43:16 AM »
Hello,  Count me in at 2,375,640

6
LazyCam (Beta) / Re: Lcam 2.0...
« on: May 16, 2007, 02:50:39 PM »
Hello,

Just get my licence key for lcam. Now i'm trying to load my file but the drawing is verry difrend than the old version of lcam.


I'm not getting strayt lines and the round corners are not right.

Screenshot i've send to see the problem.

regards Bas

7
LazyCam (Beta) / Re: only smal part in mach3 3
« on: April 21, 2007, 05:26:30 PM »
Ok then i purcase a licence

Regards Bas

8
LazyCam (Beta) / Re: only smal part in mach3 3
« on: April 21, 2007, 04:18:35 PM »
Hello Graham,

But when i only purcase mach3 its no problem to mill these file's.

regards Bas

9
LazyCam (Beta) / Re: only smal part in mach3 3
« on: April 21, 2007, 04:04:33 PM »
Ok Graham, thats the problem. Do i need only a licence for mach3 or also for lazycam?

regards Bas

10
LazyCam (Beta) / Re: only smal part in mach3 3
« on: April 20, 2007, 03:14:38 PM »
Hello,

Picture on this link:
http://www.homecockpitbuilder.com/mach3

Gcode on this file

http://www.homecockpitbuilder.com/gcode.tap


Hello Brain,


Can you explane what a spine means?

Regards Bas

Pages: 1 2 »