Hello Guest it is January 23, 2021, 10:49:40 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Modifier

Pages: 1
General Mach Discussion / Precix Retrofit Advice
« on: November 21, 2012, 07:47:01 AM »
Apologies in advance if this is posted under the wrong board, couldn't figure out where it fit best.

I have a 2-3 year old 5' x 10' Precix Servo-based (Delta) CNC-Router and am heavily considering replacing the controller.  Considering Mach3 as the base platform, any recommendations on quality drive interfaces and motion controllers?  This is not a commercial machine, but is used heavily, so reliability and precision is important.

Pages: 1