Hello Guest it is May 30, 2023, 08:12:04 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - andrewbishop66

Pages: 1 2 3 »
has anyone tried this with machstdmill I like the idea of this and would like to use it with mach standard mill

Thanks andrew

Bob has contatcted me and is shipping a new chip first class service


PoKeys / Is there a begineers guide to pokeys
« on: October 08, 2013, 07:10:07 PM »
I have a mill that has two parallel cables can pokeys replace this  i use inputs for limit's speed feedback tool height and probe plus the normal outputs XYZ A  motor control and coolant thanks


I ve been told i need to get hold of bob for a replacment chip for my combo board anyone have any idea as the bobcampbelldesigns email is a no go any help would be good

Thanks Andrew

as above as i need a new pic 16f818 for my combo board made by sound logic any help is apreciated as I think i killed the chip it got a tiny bit hot

Thanks All andrew

General Mach Discussion / Re: OT. Thread charts
« on: May 20, 2012, 02:27:11 PM »
thanks for that hood have now them at http://pages.cs.wisc.edu/~bolo/workshop/thread.html

incidently the bridgeport stepper motors i brought off you are still going great

Thanks andrew

General Mach Discussion / OT. Thread charts
« on: May 18, 2012, 06:08:52 AM »
I have in my workshop a set of thread charts listing quite a few different types of threads listed in size order that I downloaded a few years ago but now I can remember where I got them from they list the pitch major minor both in imperial and metric any one have the link
very usefull for thread milling ect
Thanks Andrew

General Mach Discussion / cant open notepad in mach 3
« on: April 11, 2012, 05:35:07 PM »
As the title says when I hit edit g code a small window opens (not notepad ) and then closes again and the code refreshes and that's it it worked in the  past until I tried Mach standard screen and now im back to the old one it dosnt any help please

Thanks Andrew

General Mach Discussion / Re: upside down help
« on: February 10, 2008, 02:28:42 PM »
the problem was I just needed to click my display mode button

thanks for the help though

andrew bishop

General Mach Discussion / Re: upside down help
« on: February 06, 2008, 03:47:01 PM »
OK found problem and am to embarrassed to say what it was but thanks for the help

Pages: 1 2 3 »