Hello Guest it is November 29, 2021, 12:44:33 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Wylee

Pages: 1
1
General Mach Discussion / Mach 3 running a K2 CNC KT2514
« on: November 06, 2012, 07:21:02 PM »
Does anyone have Mach 3 running a K2CNC KT2514? I have a 2008 with servos using the Gecko G320 DC servo drives and a K2 breakout board that I haven't identified yet. I'm just installing Mach 3 to this machine and I have it to the point where I can jog the DRO's with my arrow keys but I can't get any motor movement. Port configuration was easy enough but I'm not confident about any of my pin configurations for motor outputs, input signals, output signals and encoders. Can anyone provide me with this info? Keep in mind I'm relatively new to this technology. 

Pages: 1