Guest
Show Posts
1
General Mach Discussion / Mach3 not responding after closing wizard
« on: November 02, 2012, 03:43:51 AM »
Hi everyone,
I've a problem regarding all wizards in M3. Closing the wizard to post the g-code generated and return to the normal screen stalls M3 for a short moment. M3 is simply "not responding" using the windows term. It's about 1-2 seconds and in that timespan the carge-pump signal is not send and my machine-control goes to e-stop.
I'm running Win7 with nothing but M3 installed, no lan or wlan. The controller is attached via LPT. Drivertest runs perfectly.
I think it might happen on opening the wizard-generated file after closing the wizard, but opening a g-code-file from the normal screen works without problems. Running small or large g-code is working without problems.
Maybe someone encountered this problem and could give me a tip?
Thanks
Michael
I've a problem regarding all wizards in M3. Closing the wizard to post the g-code generated and return to the normal screen stalls M3 for a short moment. M3 is simply "not responding" using the windows term. It's about 1-2 seconds and in that timespan the carge-pump signal is not send and my machine-control goes to e-stop.
I'm running Win7 with nothing but M3 installed, no lan or wlan. The controller is attached via LPT. Drivertest runs perfectly.
I think it might happen on opening the wizard-generated file after closing the wizard, but opening a g-code-file from the normal screen works without problems. Running small or large g-code is working without problems.
Maybe someone encountered this problem and could give me a tip?
Thanks
Michael