Hello Guest it is June 20, 2021, 09:43:23 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - saiz13

Pages: 1
1
General Mach Discussion / Re: Motor problem
« on: October 24, 2012, 06:51:23 AM »
in order to control how top give pulse to the parllel port from mach3 settings are needed

saiz

2
General Mach Discussion / Re: Motor problem
« on: October 24, 2012, 06:50:10 AM »
Hi tweakie,

i am not using servo dc motors i am using just common dc motors of 30 rpm 12v supply. so is it possible to run this motors with mach3 software.

3
General Mach Discussion / Re: Motor problem
« on: October 23, 2012, 01:37:34 AM »
if there is better software to control the dc motor for motor controlling please send me that thing to.please help me.i cannot afford to stepper motors.

4
General Mach Discussion / Re: Motor problem
« on: October 23, 2012, 01:35:53 AM »
hi friends

i am new to cnc machine iam designing a cnc machine using dc motors for axis control instead of stepper motors. i would like to know whether mach3 can support to dc motors for controlling axis.is there any circuit needed for this purpose can u please help me in this case.please guide me through this. becoz this is my academic project.

5
General Mach Discussion / Re: mach3 Gear DC motor control.
« on: October 23, 2012, 01:17:56 AM »
hello friends ,

i am new to cnc machines i dont know any thing about cnc machines for my academic project i have designed a cnc carving machine basic design using dremel 300 rotary tool but for axes motors iam using dc gear motors of 30 rpm.why because i can't afford for stepper motors. i would like to know whether mach3 can support for dc gear motor control from motor outputs option in it. i need reply soon.because my project demo is near by. 

Pages: 1