Hello Guest it is March 29, 2024, 10:53:20 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - EFI-Unlimited

Pages: 1
1
General Mach Discussion / Re: 2.5D
« on: April 18, 2007, 09:22:19 AM »
Chad,
  I thought for sure that with all the specialized functions that Mach has, it would have a 2.5D option.  Seems like it would be wasy to implement.  Anyways, if anyone knows how to make this happen painlessly it would be appreciated.  Maybe it could be included in the next Mach release.....

  As for being 2/3 of the way there.... putting control on the quill looks like a major, where the cross slides are pretty easy, unless someone has some fancy way of doing it without a lot of drama.

Brian

2
General Mach Discussion / 2.5D
« on: April 16, 2007, 11:10:53 PM »
I have just installed and setup Mach 3 on my knee mill.  I am 2 axis at the moment, and I was wondering if there was a way to configure mach to operate in 2.5D mode.  I know I can get a CAM program to do it, but the wizards in Mach are nice, and it would be a pain to export the Gcode, add the 2.5D optional stops, and reload it.  It would be great if there was a way to make Mach feedhold whenever the Z axis moves.

Brian

Pages: 1