Hello Guest it is March 28, 2024, 10:41:06 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Jimchi52

Pages: 1 2 3 4 5 6 »
1
General Mach Discussion / Changing computers
« on: September 13, 2017, 10:19:54 PM »
What files do I need to copy to my new computer?

2
General Mach Discussion / Re: Ess smoothstepper
« on: April 16, 2017, 10:59:02 AM »
Running finish cut now. See what happens today

3
General Mach Discussion / Ess smoothstepper
« on: April 15, 2017, 10:30:23 PM »
Stopped three times today while running a program.Other times it runs fine.I switched my older machine from usb to ess and it runs fine.Help

4
SmoothStepper USB / Re: Welcome to SmoothStepper forum.
« on: April 15, 2017, 10:27:28 PM »
I have the ess smoothstepper and today it stopped three times.What could be the problem?

5
General Mach Discussion / Z setting
« on: February 10, 2017, 10:02:03 PM »
I had my z home setting at -4.5 still not sure why.Now I lowered my router how do I know what to set it at now

6
General Mach Discussion / Re: Cutting to deep
« on: August 15, 2016, 01:38:36 PM »
I have a zero plate I bought awhile back but did not know how to set it up

7
General Mach Discussion / Re: Cutting to deep
« on: August 15, 2016, 10:07:00 AM »
Vetric pro
Set cutter down manually to top of my stock then 0 it

8
General Mach Discussion / Re: Cutting to deep
« on: August 14, 2016, 02:57:14 PM »
Set my cutter on my job I am cutting

9
General Mach Discussion / Cutting to deep
« on: August 14, 2016, 02:12:03 PM »
I have my program set to cut .0625 and it is cutting .125. Any ideas?

10
General Mach Discussion / Re: Z axis will not go up
« on: June 08, 2016, 04:40:31 AM »
What was strange is it happened in the middle of my table where the soft limits were not set at. Had to restart my whole program. Luckily I wrote down the x and y settings

Pages: 1 2 3 4 5 6 »