Hello Guest it is March 29, 2024, 09:35:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Dale Seguine

Pages: 1
1
Mach3 under Vista / Re: Mach3 cutting everything backward
« on: October 13, 2012, 05:30:16 PM »
Thanks for your reply, but it's 4 days later and still do not have a clue.
If it helps, I purchased my machine from mydiycnc.com (small desktop).
    Generalized answers are no good to this nubie.
If only I can find someone to give me step by step instruction....
Thanks.
Dale

2
Mach3 under Vista / HELP NEEDED! I WILL PAY!
« on: October 12, 2012, 06:04:07 PM »
Please Help!

If there is someone in the Columbus Ohio area and willing to meet me to help me set up my Mach3 and my small desktop cnc machine, Please contact me.

I am willing to pay $$$$$.

Thanks in advance for your help ???
Dale.

3
Mach3 under Vista / Mach3 cutting everything backward
« on: October 09, 2012, 12:29:06 PM »
Mach3 is cutting everything backwards.

Newbie here.....Just purchased Mach3.
If anyone can help, I finally got an item cut out (6" miniature guitar), but it is cut out backwards.
Anyone have a similar problem and Solution?

Thanks for your replies.
Dale

4
Hello all,
My name is Dale, I am a NEWBIE, and in need of some SERIOUS help.

All I wanted to do was to make miniature guitars. My intentions were a nice relaxing hobby to keep me calm after my heart attack and open heart surgery. Turns out, Relaxing hobby is out of the question. (But I still go on).

When I purchased my kit from mydiycnc.com, I did not realize the difficulties I was getting myself into.
The LACK OF "one-on-one" human customer support for CNC in general is leaving me disappointed.

I do not know about forums, and what I have seen so far, the support for INDIVIDUALIZED help is difficult as well.
I hope all that changes since I purchased Mach3 control Software and Vectric 2D software.
I've had so many misfortunes along the way, I chose to purchase the Best, even being on a low fixed "Social-Insecurity" income.

If there is individualized help, I sure would appreciate it. After my 2 recent purchases, I am still having problems with getting a miniature guitar (about 6 inches) cut out.
Thanks.....Dale.


Pages: 1