Messages

1

General Mach Discussion / Re: Please Help!! Mach 3 homing issues

« on: October 05, 2012, 02:42:17 PM »

Here it is. 

2

General Mach Discussion / Re: Please Help!! Mach 3 homing issues

« on: October 05, 2012, 02:15:28 PM »

Hi
Thanks for a reply.  Please bear with me because I am fairly new to cnc.  What xml are you looking for and where will I find it?

3

General Mach Discussion / Please Help!! Mach 3 homing issues

« on: October 05, 2012, 01:10:44 PM »

Hi,
I am new to this forum so any help would be greatly appreciated.  On the program run screen I am getting an abnormal condition message when I reference all axis home.  When I click on the abnormal condition tab it reads "Axis are not Refed to normal condition".  If I turn the controller on and jog around everything is fine normal condition appears until it homes out.   I ran a program with no problems until I increased the feed rate then the machine ran away.  Luckily I e stopped it before it crashed.  I am thinking that this has something to do with the abnormal condition message.  What could I try to fix this problem?