Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 11classic

Pages: 1
1
G-Code, CAD, and CAM discussions / Tool Lenght from Probe
« on: October 04, 2012, 07:51:27 AM »
I am having a hard time finding any information on using a G31 Z-********* command. I get the tool to travel down and stop on the probe.  I think the the value of that position is in #2003. I would like to write that value to the tool table #tool table = #2003. The end goal is to use the probe to check if the tool is broken during a lights out operation.

Pages: 1