Messages

1

G-Code, CAD, and CAM discussions / Re: New setup

« on: September 26, 2012, 06:38:23 AM »

Graham, Thanks for your help. I'm going to try a complete reinstall of the software. Things don't seem quite right with the software.

2

G-Code, CAD, and CAM discussions / New setup

« on: September 23, 2012, 07:52:07 PM »

I have a new router from ebay. I have a licensed copy of Mach3. I am just setting it up. I have not been able to cut anything. The motors are buzzing and trying to move but don't. Then I found a demo gcode on here of a scorpion. The router runs perfectly with that code in there. If I try to even cut the roadrunner file in the mach3 software, nothing but buzzing. Any idea what I might have done wrong?

Thanks, Darrel