Messages

1

General Mach Discussion / Re: Parameters - how to show the numeric values ??

« on: October 30, 2014, 06:50:22 AM »

BR549 Excellent thanks - sounds like the answer to my problem - but where is it located please  , 
I have searched evrywhere I can think of but not located - nothing in manual.

Many thanks

2

General Mach Discussion / Parameters - how to show the numeric values ??

« on: October 27, 2014, 07:00:42 PM »

How can I show the values of parameters which are being used by the program ??

I am working on a general purpose code to execute a series of moves (G0, G1, G2 or G3) using data from a table - but there is a problem somewhere and I need to know if the correct values are being entered into parameters from the table - but I cannot find in the manual any way to see the values as the program is running.

Any ideas most appreciated - when I have fixed it I will publish here.

3

FAQs / Re: Axes position at start up

« on: September 22, 2012, 07:23:04 AM »

Excellent - thanks very much.

4

FAQs / Re: Axes position at start up

« on: September 22, 2012, 04:43:17 AM »

Hi RICH,

It is Sieg (type) smallest lathe with mill head running XYZ, no limits or homes (yet).  I normally park in a safe place and would like start up values zero'd just in case I make a move to zero (always in abs mode) having forgotten to set the axes to zero as I have done a couple of times now.

5

FAQs / Axes position at start up

« on: September 21, 2012, 10:00:14 AM »

When I open Mach3 the current axes positions appear to have random values.  Is there a way to make these start up at zero ?, value as at previous close down ? or a preset value ?  Thanks