Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Not only resistors, kind of IC on the bottom.I think this is PIC16F629 and I thing pg must be programmed ....
1.5 to 2.5 msec pulsewidth PWM.
found this on YouTube
http://www.youtube.com/watch?v=DUzuEt8fmJ8
The Pokeys device has adjustable PWM outputs.
Alex
Here's the answer for non electronics wizards (such as myself) that can't build their own. http://www.logicnc.com/rcnc.htmlI know this solution but it is not cheap.if you look the video this man use the brushles motor and the esc only . And some resistors . How can I make this
Interesting question which I'm curious to hear a learned response to. I've run R/C planes, boats & cars for 40 yrs without knowing much about the magic "behind the scenes." This link explains a bit about how they work. http://en.wikipedia.org/wiki/Servo_controlI don't know if it is simple task but I can do the motor run... I think mach doesn't produce in this frequency pulses
Seems like a simple task for Mach, yes?
What type of input signal does the speed controller require, PPM, PWM or just variable frequency?esc need pwm signal.. Every 20ms
?
Guest
