Hello Guest it is March 29, 2024, 01:20:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - shockwavefx

Pages: 1
1
General Mach Discussion / Re: Very new to this
« on: September 18, 2012, 12:55:07 AM »
Thank you for taking the time to help with this.

I'm not sure what it is that you are asking for
What is the xml?

2
General Mach Discussion / Re: Very new to this
« on: September 17, 2012, 01:20:20 PM »
G00 X25.5 Y0 Z0
G00 X35.5 Y.800 Z0

3
General Mach Discussion / Very new to this
« on: September 17, 2012, 12:58:16 PM »
Hi
Sorry if I'm not following proper procedure in here.
Very new to all this and forums.
Trying to test some moves on my machine.
Every time the program get to the second line of code it goes into a cutting federate mode/speed even though
the code is calling for rapid positioning.
Can anyone help.?

4
Hi

I'm have no experience with mach3 But have an urgent project I need to complete.
Looking for some local help in the San Fernando Valley area of Los Angeles.
It's a very simple project from what I've read so far.
seems like it would be a simple G code program written into mach3. I just have gotten into a situation where I don't have the time to figure this out.
Pls reply to shockwavefx@yahoo.com if you can help. May be able to compensate you for your time.  THX

Pages: 1