Hello Guest it is December 05, 2021, 10:16:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - NEUengineer

Pages: 1
1
General Mach Discussion / Re: PCIE parallel port address
« on: September 10, 2012, 06:53:25 PM »
So i'm pretty sure the address is "0x4000". If i enter this, my controller box goes from ready to alarm, and i can get some intermittent functionality out of my Estop button. When using the autotune feature, do i need to make a connection for it to detect the pin, or do i need to send a voltage across the pin? I'm trying to determine if i'm talking to it by triggering the Estop and having it tell me what pin i'm using, but it's jumping around between pin 10, 11 and 15. 15 being the correct pin.

2
General Mach Discussion / Re: PCIE parallel port address
« on: September 10, 2012, 05:51:59 AM »
I can also boot up using what's called Boot Camp, which is different from Parallels in that it boots up exactly like Windows does on any other machine. But since I'm using a PCIE card, it's still not the default port address. How would you normally find the address of a PCIE parallel card?

3
General Mach Discussion / PCIE parallel port address
« on: September 09, 2012, 09:43:48 PM »
Hi,

I have a MacPro desktop running Parallels 7 so that I can use Windows 7 - 32 bit. The problem is that I do not have a "Ports" row under Device manager. How do I find the address of my PCIE parallel card?

Pages: 1