Hello Guest it is November 29, 2021, 01:15:09 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Michel S.

Pages: 1
1
General Mach Discussion / Re: Machturn
« on: August 07, 2009, 11:14:53 PM »
try this program it will convert your inch output to mm


http://tinyurl.com/3omytt

Michel

2
General Mach Discussion / Re: Mach 3 french version etc...
« on: September 25, 2006, 11:58:55 PM »
Ant
email me your machuine hardware setup.
I will try to give you initial instructions in French to make your motors move.

Michel S.
micsit1@gmail.com

3
Looks terrific.
I just envy those guys that can play with screen setups. I wish I could have the same display on my Mach3 program.
I haven't got a clue how to do it. I can't even resize my standard screens to show all the data.
Is there any documentation somewhere on how to play with them?

Thanks, keep going. It is a tremendous help for us newbies to see the potential Mach3 can demonstrate.
Michel

4
General Mach Discussion / Dwell in Mach3
« on: March 11, 2006, 08:46:07 PM »
Dwell Active Lead light is OFF on diags screen.
Does someone knows how to set it on?
Thanks,
Michel

Pages: 1