1
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: September 02, 2012, 07:58:51 PM »
Greetings to all;
My name is Pete Nunez and I am new to the forum and also new to CNC. I recently purchased a Phlatprinter 3, a hobby grade cnc machine which is powered by a Gecko G540 using Mach3. I was wondering if anyone could tell me or point me in the right direction in regards to the calibration of this machine. So far all systems perform well, with very few bugs, however it would be great to learn how to go about the calibration procedure.
thank you, hope hear from all of you soon;
Pete
My name is Pete Nunez and I am new to the forum and also new to CNC. I recently purchased a Phlatprinter 3, a hobby grade cnc machine which is powered by a Gecko G540 using Mach3. I was wondering if anyone could tell me or point me in the right direction in regards to the calibration of this machine. So far all systems perform well, with very few bugs, however it would be great to learn how to go about the calibration procedure.
thank you, hope hear from all of you soon;
Pete